How to connect an EVC2

  On 19/05/2023 at 18:45, Avacado said:

It was more like a stinky fizzle than a boom.... 

Expand  

Only because I was far away, if I was closer it would probably be more spectacular

  On 19/05/2023 at 18:35, damric said:

Well I think Afterburner's limits were 1.3v or so for that card so I'm hoping to see if you get some good scaling past that. The most I was able to bench was 1050MHz looking back at my hwbot subs from that card.

Expand  

I did 1130 on the not so impressive Club3D card @ 1.35v. I'm now working on the Sapphire Toxic, which seems to have a decent pcb. Keep your fingers crossed that the core is gold too

  On 19/05/2023 at 17:26, Bastiaan_NL said:

It allows you to change it both ways, instead of a normal resistor mod. Which means you can also undervolt a GPU if you like that, or make it go boom (ask @Avacado)

The software is easy, the mod is not too complicated and it looks better than pot-meters on the pcb. I am planning to do the same mod on my next project, and I hope to go into more detail there.

Expand  

It was more like a stinky fizzle than a boom.... 

  On 19/05/2023 at 02:47, Avacado said:

As much as you want. 

Expand  

Well I think Afterburner's limits were 1.3v or so for that card so I'm hoping to see if you get some good scaling past that. The most I was able to bench was 1050MHz looking back at my hwbot subs from that card.

  On 19/05/2023 at 02:14, damric said:

How much voltage were you able to apply?

Expand  

It allows you to change it both ways, instead of a normal resistor mod. Which means you can also undervolt a GPU if you like that, or make it go boom (ask @Avacado)

The software is easy, the mod is not too complicated and it looks better than pot-meters on the pcb. I am planning to do the same mod on my next project, and I hope to go into more detail there.

  On 19/05/2023 at 02:14, damric said:

How much voltage were you able to apply?

Expand  

  On 19/05/2023 at 02:14, damric said:

How much voltage were you able to apply?

Expand  

As much as you want. 

How much voltage were you able to apply?

This EVC2 is connected to work as a feedback mod instead of using resistors. The nice thing is that it also monitors voltage and can be used for negative and positive change in voltage which sometimes helps with memory overclocking.